MC9S08SV16
PROJECT BOARD

This is a project board for the MC9S08SV16. It is a full featured MCU with all peripherals, has 16K of Flash memory and uses a 5 volt power.  It is packaged in a 32 pin SDIP.

 
In the photo at top and to the left the Project Board is connected to a four line character LCD by the SPI2LCD interface.
Click for a larger image To the left is a photo of the bare project board and below that is a populated one.
Click for a larger image

Note that this project board includes a space for a Serial EEPROM and also a DS1307 Real Time Clock chip. See my Software for the DS1307 page.  Be careful when installing the parts; the back-up battery happens to be next to the EEPROM chip not the clock IC.

 

Note the DB9 can either be mounted on the board or off-board and connected to a header.

 

Here is software for a program to read the DS1307 RTC and display the results on a LCD.

Here is a schematic of the board.

The MC9S08SV16 project board  is for sale. Check the ordering page.

Minor issues with board

The Project Board is designed for the 32 pin MC9S08SV16.

See also the very similar Project Board for the MC9S08QG8 and MC9S08QE8.
And also similar to the MC0S08SH8 Project Board.

The MC9S08SV16 is also used for the 40 key 5x8 membrane keypad interface.  See photo to the left. 

And for a project board using an Arduino form factor.  See photo to right.

Arduino Form Factor

For BDM's

  Lowest cost.

 

 

The 9S08 family is programmed using a Background Debug Module and Code Warrior.  CW can be downloaded from the Freescale website.

 

 

Roger's Embedded Microcontrollers Home Page     


This page written by Roger Schaefer. Last updated July 21, 2012